Cyclones

There is a spiral twisting of the flow occurs in the cyclone, resulting in the particles under the action of centrifugal forces is discarded to the periphery and sliding down along the wall, and their final separation from the gas stream occurs in the lower part of the cyclone, where the flow turns towards the exhaust pipe. Caught thus the solid particles are poured into a hopper.

Cyclones are the most common and relatively effective machines for dedusting the inertia type. Since the inertial force is proportional to mass, the fine particles are captured in cyclones bad. So the cleaning efficiency of aerosols in the direct-flow cyclone with a particle size exceeding 10 µm are in the range 80-95 %, and with size less than 10 microns to below 70 %, which narrows the scope of the cyclones. The fields of application of traditional cyclone are converging in connection with restrictions on the temperature of cleared gases (up to 400 °C) and high demands on wear resistance of the material of the cyclone at the collection of highly abrasive dust. However, due to the design characteristics of cyclones offered by us, they are devoid of these limitations.

We offer a wide range of highly efficient cyclones, providing cleaning dusty gases with a temperature of over 1500 °C to 99% at particle sizes of 10 µm. In the manufacture of our cyclones are used hard and tough materials, to increase productivity in the clean gas it is possible to design a battery of cyclones with different structural solutions. If necessary, it is possible to manufacture cyclones high pressure (300 bar); wear liners; with built-in heat exchangers; for high paleogreens (20 t/h).